Rolla, MO 65401
ph: 214-650-9697
alt: 573-578-1331
bob
SURFACE CARE OF RESURFACED ITEMS
Your new surface was designed and applied to allow you to enjoy it for many years. Please follow the instructions below to keep it looking fresh.
INITIAL CARE
Surfaces will be dry to touch quickly after application but should not be used for 24 hours to preclude damage. Chemical cleaners must be avoided during the first couple weeks and rinsed off completely when used. An antibacterial dish soap can be used to clean if necessary. Regular cleaning and normal use should remove any dust particles that settled in the finish after application.
DO NOT let soap, bottles or any other object lay on the finished surface. Ensure faucet taps are dry and are not dripping.
Counter Top Specific Instructions:
- during the first week after application, take extra precaution to protect the surface from the heat caused by small appliances (slow cooker, coffee pot...). Sit any heat generating appliance on a hot pad or trivet. Follow your small appliance manufacturers instructions.
- wait 72 hours after application to place heavy appliances (microwave) back on the surface. Protect surface if sliding heavy objects.
Tub and Shower Specific Instructions:
- DO NOT use suction cup mats as they could pull off the new coating. Non-slip can be built-in to the new coating or a vinyl stick-on (strips or mat) can be applied afterwards.
- properly maintain faucets because a leaky faucet can erode the new finish and reduce life expectency.
-repair damage (chips...) to avoid additional damage.
LONG TERM CARE
Any cleaning product approved for use on fiberglass and Acrylic products is acceptable. As with all kitchen and bath surfaces new or refinished, DO NOT use any abrasive cleaners or cleaning pads. A clean dry surface will keep your new surface looking fresh. Remove any product or chemical from the surface. Even though your new surface is resistant to staining and damage it is good to keep it clean to avoid such effects. Remove any spilled items that can stain (hair dye, tea, fruit drinks…) or react (pure bleach, acid…) quickly to avoid damaging the surface. You can clean and polish the surface as you do other fiberglass and Acrylic products.
If you have any questions, please call us.
Copyright 2010 Ace Resurfacing. All rights reserved.
Rolla, MO 65401
ph: 214-650-9697
alt: 573-578-1331
bob